Welcome to Silver Earth Metal - Australian Made - Nationwide Delivery

How to Install a Letter Box in your door?

After buying a letterbox, one main question that comes to our mind is how to install it? So, you don’t have to worry about it, because for this purpose you are going to need a few tools that are easily available in the market.

  • Pencil to draw lines
  • Your letterbox
  • A jigsaw
  • A file
  • Drill machine
  • Spirit level
  • Scale or ruler
  • Measuring tape
  • Hammer
  • A spanner

These are some basic and essential tools that are required to set up a letterbox outside of your house. Here in this article, we will guide you step-by-step, and by following all these you can easily set it up.

Steps to Set up a Letterbox

  1. Discover the Centrepoint

To begin with, we will indicate the job of the gap on the entranceway. It will permit us to see precisely what the hole will look like until we create some permanent adjustments to improve some minor crookedness.

However, how can you quantify a letterbox? There is a hint for this. You would like your letterbox to beat the entranceway's exact center-point; therefore, take your tape measure and assess the width of this entranceway. Subsequently, mark a place mid-way across.

You may additionally want to accomplish the very same with height, even though a letterbox that is too much into the left or straight can look a lot more out of place than just one that is marginally too significant.

  1. Identify Hole

Next, we will draw a rectangle around our midpoint. Use your ruler and the spirit level to find every advantage right. It is possible to begin by producing a short vertical line upwards from the mid-point (half of the elevation of the end letterbox) and drawing on the rectangle from that point. Once you are done, double-check every angle and advantage.

We may begin drilling several openings. All these are precisely what your jigsaw will be stitched through. You want one in each nook, large enough to screw the blade. The sides of every hole will want to be pretty much touching the boundary of this rectangle you've attracted. Make sure you preserve the drill flat, as repairing a jagged hole is a significant pain.

  1. Process of Drilling

We may begin sawing. When you've never applied a jigsaw earlier, then this may establish a small challenge. The saw will probably take good care of nearly all the job with you, which means you won't need to employ such force. Please stay in the lines instead of straying them outside, as you will use the document to improve some residual bumpiness after you are done.

  1. Smooth Corners

It is the right time to clean workout. Utilize your document to go across the borders. Go at your own pace, and be sure that you never go too much. That you don't need smooth corners since the letterbox itself will hide modest imperfections.

  1. Twist the Letter-box

Now, it’s time check if the box fit into it or not. You are only likely to screw it through the pit to be certain everything works properly. If it will, you are prepared to put in more durable fixtures.

  1. Indicate the location of stud

Before you begin drilling the studs, then you will have to indicate the locations. There is a trick to achieving so accurately. Only take your letterbox, studs, and then keep it within the entrance way. Will likely indicated your stud location into the timber.

  1. Drilling of the Holes

Now it is the time for you to drill the accurate holes for studs. You can achieve it by first drilling a pilot hole to make matters easier.

  1. Blend your nuts

Eventually, they may twist the nuts to repair the letterbox right into place. If there's some surplus, then you can cut it with a hacksaw.

Conclusion

We hope now it is clear for you all to understand how you can install a letterbox into your door. For further information you can contact us or also have a look at some of our products like metal wall art, fire pits, and metal letterboxes etc.

Leave a comment

Please note, comments must be approved before they are published